Male Tank Fitting
- Designed for use in tanks, troughs and a wide variety of marine applications.
- Manufactured from UV Stabilised High Quality Glass Fibre Reinforced Nylon.
- Material Approved for use with Potable (drinkable) Water making them ideally suited to a broad range of rural & domestic applications
- Precision Heavy Duty Tapered Threads give a Strong Reliable Seal
- Material is strong enough to minimise potential cross threading
- 15-50mm 16 Bar-1600kpa-235psi pressure rating
Installation
- Prior to installation, refer to Tank manufacturers recommendations before drilling outlet in tank wall.
- Use a thread sealant on all threaded connections.
- Please refer below for Minimum Recommended Hole Sizes.
- Check the sealing surface to ensure it is free from debris and/or scratches which could cause leakage.
- To obtain proper washer compression for fitting installation ensure the face of the washers fully contacts the tank wall.
- Tighten the nut to ensure a water tight seal.
RECOMMENDED HOLE SAW SIZES
15mm = 22mm or 7/8" Hole Saw
20mm = 27mm or 1 1/16" Hole Saw
25mm = 34mm or 1 3/8" Hole Saw
32mm = 42mm or 1 5/8" Hole Saw
40mm = 48mm or 1 7/8" Hole Saw
50mm = 60mm or 2 3/8" Hole Saw